5/17/2023 0 Comments Rv power converter troubleshooting![]() Ensure you do not get the mixture on your hands, trailer, or clothes to create burns. Let the mixture sit for a couple of minutes before wiping the terminals with a clean rag.Clean the cable clamps paying particular attention to the inside of the clamps where the connection is made to the terminal. Then take a more rigid brush such as a toothbrush and scrub and carefully scrub the baking soda and water into the terminal posts.Allow the mixture to fizz for a minute or two to neutralize the acid. Take a soft brush such as a paintbrush dipped in water and applied it to the baking soda rings, ensuring you do not splash the mix.Pour a small amount of baking soda directly onto your terminals in a ring to neutralize the sulphuric acid before you clean it off.Disconnect the battery by removing the cables from battery terminals starting at the negative terminal and taking care not to touch both terminals at once.It would be best if you cleaned your battery terminals to remove the corrosion in this simple process. One should check for battery electrolyte levels at least once a month, and you should fully charge your batteries before you perform maintenance as charge levels may change your electrolyte levels. Proper treatment of a battery after discharge will help prevent sulfation and maintain your battery’s electrolyte levels. ![]()
0 Comments
Leave a Reply. |